Note when installing debian : http://groups.google.com/group/linux.debian.bugs.dist/msg/7b05436df66934a3

Linux's "eth0" is the physical "Port B" (I put a sticker over it marked eth0).  "eth1" is "Port A".  Just keep this in mind.

Both disks have a small partition (part1) and a big partition (part3).  The big partitions are RAID1'ed together; the small partition on the first drive is boot, the second drive is swap.

Also: http://www.openafs.org/pipermail/openafs-info/2006-November/024356.html

== Console ==

Mire's ttyS0 is connected to krunk's LOM port.

To access Krunk's console, log in to mire and type

{{{
sudo cu -s 9600 -l /dev/ttyS0
}}}

This will give you access to Krunk's console.  We have told Krunk not to respond to BREAK signals on the serial line ({{{echo 0 > /proc/sys/kernel/stop-a}}}), so in order to get its attention when it is stuck you must use the LOM attention sequence -- #.  (return, hash mark, period).  This will give you the {{{lom>}}} prompt; type {{{console}}} to go back to Krunk's console.

To exit {{{cu}}}, type ~. (return, tilde, period).  You might need two tildes if you're on an ssh connection.