|
⇤ ← Revision 1 as of 2008-02-11 22:18:10
Size: 324
Comment: Initial contents
|
Size: 548
Comment: Mention krunk and minicom
|
| Deletions are marked like this. | Additions are marked like this. |
| Line 5: | Line 5: |
| 2. Power off the "platform", which is the normal processor. {{{ | 1. Power off the "platform", which is the normal processor. {{{ |
| Line 7: | Line 7: |
| 3. Wait a few minutes. 4. Power on the platform. {{{ |
1. Wait a few minutes. 1. Power on the platform. {{{ |
| Line 10: | Line 10: |
| 1. Krunk will have halted, because its serial port is connected to mire, and it gets messed up when rebooting. Turn it back on again by logging into mire and doing the following. {{{ minicom -o boot <exit minicom>}}} |
This page explains how to reboot mire using the SP interface.
Log into the SP using ssh.
ssh admin@69.90.123.71
Power off the "platform", which is the normal processor.
platform set power state -f off
- Wait a few minutes.
Power on the platform.
platform set power state -f on
Krunk will have halted, because its serial port is connected to mire, and it gets messed up when rebooting. Turn it back on again by logging into mire and doing the following.
minicom -o boot <exit minicom>