1. Reboot via Service Processor

Log into the SP using ssh.
```
ssh admin@mire-sp.hcoop.net
```
Power off the "platform", which is the normal processor.
```
platform set power state -f off
```
Wait a few minutes.
Power on the platform.
```
platform set power state -f on
```

2. Post-boot

After boot, run sudo /etc/init.d/domtool-slave start, as it seems that domtool-slave does not start up automatially.

-  ⇤ ← Revision 4 as of 2008-10-02 02:52:38 → 
  Size: 553
  Editor: netblock-68-183-203-20
  Comment:
+   ← Revision 6 as of 2010-01-21 13:12:06 → ⇥
  Size: 508
  Editor: dslb-092-074-055-194
  Comment:
-Deletions are marked like this.
+Additions are marked like this.
 Line 2:
+= Reboot via Service Processor =
-Line 10:
+Line 12:
-. Krunk will have halted, because its serial port is connected to mire, and it gets messed up when rebooting.  Turn it back on again by logging into mire and doing the following.  {{{
minicom -o
boot
<exit minicom>}}}
+= Post-boot =

After boot, run '''sudo /etc/init.d/domtool-slave start''', as it seems that domtool-slave does not start up automatially.