329
Comment:
|
← Revision 6 as of 2010-01-21 13:12:06 ⇥
508
|
Deletions are marked like this. | Additions are marked like this. |
Line 2: | Line 2: |
= Reboot via Service Processor = |
|
Line 10: | Line 12: |
= Post-boot = After boot, run '''sudo /etc/init.d/domtool-slave start''', as it seems that domtool-slave does not start up automatially. |
This page explains how to reboot mire using the SP interface.
1. Reboot via Service Processor
Log into the SP using ssh.
ssh admin@mire-sp.hcoop.net
Power off the "platform", which is the normal processor.
platform set power state -f off
- Wait a few minutes.
Power on the platform.
platform set power state -f on
2. Post-boot
After boot, run sudo /etc/init.d/domtool-slave start, as it seems that domtool-slave does not start up automatially.